LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860428Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the engine wiring harness electrical connector (8) from the bank 1 intake CMP actuator solenoid valve.
    2. Fig 2: Identifying CMP Actuator Solenoid Valve Bolt & Valve
    GM1860460Courtesy of GENERAL MOTORS COMPANY
  2. Remove the CMP actuator solenoid valve bolt and valve (2).
  3. Inspect the CMP actuator solenoid valve seal and replace as necessary.
scientia non olet · About LEMON Manuals