LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CMP Actuator Solenoid Valve Bolt & Valve
    GM1860460Courtesy of GENERAL MOTORS COMPANY
  1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the CMP actuator solenoid valve (2) and bolt.

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860428Courtesy of GENERAL MOTORS COMPANY
  3. Connect the engine wiring harness electrical connector (8) to the bank 1 intake CMP actuator solenoid valve.
scientia non olet · About LEMON Manuals