LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 435 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the park brake cable over the rear suspension module.
    2. Fig 1: Park Brake Cable Eyelet And Cable Bracket
    GM1862264Courtesy of GENERAL MOTORS COMPANY
  2. Connect the park brake cable eyelet (1) to the park brake actuator.
  3. Compress the park brake cable spring and install the park brake cable to the cable bracket (2).

    Ensure the locking tabs on the cable conduit are fully engaged to the cable bracket.

    4. Fig 2: View Of Park Brake Cable Bracket Bolts
    GM1862263Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  4. Install the 2 park brake cable bracket bolts.

    Tighten 

    Tighten the bolts to 10 N.m (89 lb in).

  5. Install the park brake cable to the cable guides.
  6. Position the park brake cable to the equalizer.
    7. Fig 3: View Of Park Brake Cable & Park Brake Equalizer
    GM1862262Courtesy of GENERAL MOTORS COMPANY
  7. Connect the front park brake cable (1) to the right park brake cable.
  8. Install the park brake cable to the park brake equalizer (2).

    Ensure the locking tabs on the cable conduit (3) are fully engaged to the equalizer.

    9. Fig 4: Park Brake Cable Locknut
    GM1862259Courtesy of GENERAL MOTORS COMPANY
  9. Loosely install the park brake equalizer locknut (1).
  10. Adjust the park brake. Refer to Parking Brake Adjustment .
scientia non olet · About LEMON Manuals