LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 435 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Cable Eyelet
    GM1862261Courtesy of GENERAL MOTORS COMPANY
  1. Install the park brake cable to the cable guides.
  2. Connect the park brake cable eyelet (1) to the park brake actuator.
  3. Compress the park brake cable spring and install the park brake cable to the cable bracket (2).

    Ensure the locking tabs on the cable conduit are fully engaged to the cable bracket.

    4. Fig 2: View Of Park Brake Cable Bracket
    GM1862260Courtesy of GENERAL MOTORS COMPANY
  4. Install the park brake cable to the park brake cable bracket (1).

    Ensure the locking tabs on the cable conduit (2) are fully engaged to the park brake cable bracket.

  5. Install the park brake cable to the equalizer.
    6. Fig 3: Park Brake Cable Locknut
    GM1862259Courtesy of GENERAL MOTORS COMPANY
  6. Loosely install the park brake equalizer locknut (1).
  7. Adjust the park brake. Refer to Parking Brake Adjustment .
scientia non olet · About LEMON Manuals