Ignition Lock Cylinder Replacement

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Ignition Lock Cylinder

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement . Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement .
1	Ignition Lock Cylinder Procedure Turn the ignition lock cylinder to the RUN position. Insert a pick-type tool into the proper hole on the ignition lock cylinder case and press the lock tab on the ignition lock cylinder down. Pull the ignition lock cylinder out of the ignition lock cylinder case. If installing a new ignition lock cylinder then refer to Key and Lock Cylinder Coding .

Callout

Component Name

Preliminary Procedures

Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .
Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement .

Ignition Lock Cylinder

Procedure

Turn the ignition lock cylinder to the RUN position.
Insert a pick-type tool into the proper hole on the ignition lock cylinder case and press the lock tab on the ignition lock cylinder down.
Pull the ignition lock cylinder out of the ignition lock cylinder case.
If installing a new ignition lock cylinder then refer to Key and Lock Cylinder Coding .