LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 432 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Ignition Can/Cannot Be Turned Off with Transmission in Any Gear >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Ignition Lock Cylinder Control Switch

  1. Ignition OFF, disconnect the harness connector at the ignition lock cylinder control switch.
  2. Test for infinite resistance between terminal A and terminal B with the switch in the open position.
    • If less than specified, replace the ignition lock cylinder control switch.
  3. Test for less than 2 ohms between terminal A and terminal B with the switch in the closed position.
    • If greater than the specified range, replace the ignition lock cylinder control switch.
scientia non olet · About LEMON Manuals