LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 425 (Wheel Drive Shafts) >> Repair Instructions >> Wheel Drive Shaft Inner Joint Inspection >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front wheel drive shaft inner joint and boot. Refer to Front Wheel Drive Shaft Inner Joint and Boot Replacement .
    2. Fig 1: Wheel Drive Shaft Tripod Bushing, Housing And Clamp
    GM2056507Courtesy of GENERAL MOTORS COMPANY
  2. Remove the wheel drive shaft tripod bushing (1) from the tripod housing (3).
  3. Remove the wheel drive shaft tripod housing (3) from the wheel drive shaft.
  4. Remove the wheel drive shaft tripod joint boot bushing (1).
  5. Using a suitable cleaner, remove the excess grease from the tripod assembly.
  6. Inspect the following items for damage or excessive wear:
    • The wheel drive shaft tripod boot
    • The wheel drive shaft tripod assembly
    • The wheel drive shaft tripod joint housing
    • The wheel drive shaft tripod joint bushing
    • The wheel drive shaft
  7. If any of the internal parts are found to be excessively worn or damaged, replace the wheel drive shaft inner joint and boot. Refer to Front Wheel Drive Shaft Inner Joint and Boot Replacement .
scientia non olet · About LEMON Manuals