Assemble Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Boot And Wheel Drive Shaft

Courtesy of GENERAL MOTORS COMPANY

Position the boot and the clamp (1) on the wheel drive shaft (2), DO NOT crimp.

Fig 2: Wheel Drive Shaft, Groove And Boot

Courtesy of GENERAL MOTORS COMPANY

Ensure that the boot (1) is properly seated in the groove (2) in the wheel drive shaft (3).

Fig 3: Spacer Ring

Courtesy of GENERAL MOTORS COMPANY

Using the J 8059 pliers, install the retaining ring (2) on the wheel drive shaft (1).

Fig 4: Pliers, Breaker Bar, Torque Wrench, Ratchet & Gap Measurement

Courtesy of GENERAL MOTORS COMPANY

NOTE:

When measuring the clamp end gap dimension, the gap should not exceed 2.6 mm (0.10 in).

Using the J 35910 pliers (1), close the boot clamp (2) until the 2.6 mm (0.10 in).

Fig 5: CV Joint

Courtesy of GENERAL MOTORS COMPANY

NOTE:

The CV joint should just touch the inner retaining ring.

Using a block of wood and a hammer, install the CV joint (1) on the wheel drive shaft.

Fig 6: Lubricating Boot Of Tripot Housing

Courtesy of GENERAL MOTORS COMPANY

Place approximately half of the lubricant (2) inside the CV boot (1) and other half in the CV joint (3).
Remove any excess lubricant on the CV joint housing or the boot.

Fig 7: View Of Outboard Seal, Large Seal Retaining Clamp & CV Joint Outer Race

Courtesy of GENERAL MOTORS COMPANY

Using the J 35910 pliers, torque or ratchet wrench and breaker bar (3), close the boot clamp (1) until the gap measures 2.6 mm (0.10 in).
Move the CV joint in a circular motion 4 to 5 times to distribute the lubricant.
Remove the wheel drive shaft from the vise.
Install the wheel drive shaft. Refer to Rear Wheel Drive Shaft and Rear Axle Shaft Seal Replacement .