LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 424 (Automatic Transmission - 6T75 (M7V M7X) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0961-P0963: Line Pressure Control Solenoid Valve >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING:

    Refer to Parking Brake and Drive Wheels Warning .

  1. Engine running, transmission in Park. Move the gear shift lever into each gear position and back into Park position.
  2. Verify the scan tool parameters listed below do not display Malfunction:
    • Line Pressure Control Solenoid Valve Performance Test Status
    • Line Pressure Control Solenoid Valve Control Circuit Low Voltage Test Status
    • Line Pressure Control Solenoid Valve Control Circuit High Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing.

    • If Malfunction is not displayed 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  5. All OK.
scientia non olet · About LEMON Manuals