LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 424 (Automatic Transmission - 6T75 (M7V M7X) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0815, P0816, or P0826: Up and Down Shift Switch >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    You must perform the Circuit/System Verification first.

  1. Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the S3 Transmission Shift Lever. It may take up to 2 min for all vehicle systems to power down.
  2. Test for less than 10 Ω between the ground circuit terminal 2 and ground.
    • If 10 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
    • If greater than 2 Ω, repair the Open/High resistance in the circuit
    • If less than 2 Ω, repair the ground connection
    • If less than 10 Ω 
  3. Ignition ON.
  4. Test for 11-13 V between the signal circuit terminal 3 and ground.
    • If not between 11-13 V 
    1. Ignition OFF, disconnect the connector at the BCM.
    2. Test for infinite resistance between the signal circuit and ground.
    • If less than infinite resistance, repair the short to ground in the circuit
    • If infinite resistance
    1. Test for less than 2 Ω in the signal circuit end to end.
    • If 2 Ω or greater, repair the open/high resistance in the circuit.
    • If less than 2 Ω, replace the BCM.
    • If between 11-13 V 
  5. Ignition OFF, connect the harness connector at the S3 Transmission Shift Lever, Ignition ON, transmission shift lever in the M or manual mode position.
  6. Test for voltage between the S3 Transmission Shift Lever connector signal circuit terminal 3 and ground, by back probing the connector, for the conditions listed below:
    • 2.0-4.6 V - Plus button pressed
    • 5.1-7.3 V - Minus button pressed
    • 8.0-10.6 V - Neither button pressed
    • If voltage values are not correct 

      Replace the S3 Transmission Shift Lever

    • If voltage valued are correct 
  7. Replace the K9 Body Control Module.
scientia non olet · About LEMON Manuals