Section 422 (Vibration Diagnosis And Correction)
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Diagnostic Information and Procedures
- Vibration Analysis - Road Testing (EL-38792-A Electronic Vibration Analyzer)
- Vibration Analysis - Road Testing (CH-51450-NVH Oscilloscope)
- Component Rotational Speed Calculation
- Vibration Analysis - Tire and Wheel
- Vibration Analysis - Driveline
- Vibration Analysis - Hub and/or Axle Input
- Vibration Analysis - Engine
- Engine Order Classification
- Vibration Analysis - Engine/Accessory Isolation
- Vibration Analysis - Engine Balance
- Vibration Diagnostic Aids
- Vibration Diagnostic Aids - Vibration Intermittent or Not Duplicated
- Vibration Diagnostic Aids - Vibration Duplicated, Component Not Identified
- Vibration Diagnostic Aids - Vibration Duplicated, Difficult to Isolate/Balance Component
- Vibration Diagnostic Aids - Vibration Duplicated, Appears to Be Potential Operating Characteristic
- Symptoms - Vibration Diagnosis and Correction
- Vehicle-to-Vehicle Diagnostic Comparison
- Tire and Wheel Inspection
- Tire and Wheel Assembly Runout Measurement - On-Vehicle
- Tire and Wheel Assembly Runout Measurement - Off Vehicle
- Brake Rotor/Drum Balance Inspection
- Hub/Axle Flange and Wheel Stud Runout Inspection
- Tire and Wheel Assembly Isolation Test
- Vibration in Service-Stall Test (Non-Torque Sensitive)
- Vibration in Service-Stall Test (Torque Sensitive)
- Transfer Case Output Flange Runout Measurement
- Propeller Shaft Runout Measurement
- Torque Tube Input Flange Runout Measurement
- Pinion Flange Runout Measurement
- Differential Pinion Input Shaft Runout Measurement
- Driveline Working Angles Measurement
- Propeller Shaft Phasing Inspection
- Repair Instructions
- Description and Operation
- Special Tools and Equipment