LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 420 (Hydraulic Brake System) >> Repair Instructions >> Rear Brake Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Dust Warning .

WARNING:

Refer to Brake Fluid Irritant Warning .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: Brake Hose Bracket Bolt
    GM1862131Courtesy of GENERAL MOTORS COMPANY
  3. Remove any dirt or debris from the brake pipe fitting (1).
  4. Using a backup wrench on the brake hose fitting, disconnect the brake pipe fitting.

    Cap the brake pipe fitting to prevent brake fluid loss and contamination.

  5. Remove the brake hose bracket bolt (2).
    6. Fig 2: Brake Hose Fitting Bolt
    GM1862133Courtesy of GENERAL MOTORS COMPANY
  6. Remove the brake hose fitting bolt (1).
  7. Remove and discard the 2 brake hose fitting gaskets (2).
  8. Remove the brake hose (3).
scientia non olet · About LEMON Manuals