Rear Wheel Bearing and Hub Replacement (FWD)

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Wheel Bearing And Hub (FWD)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
CAUTION: The wheel bearing and hub assembly includes a magnetic encoder with built-in permanent magnets that the wheel speed sensor senses. Any contact with another magnet will damage the encoder magnets. The damage will cause a diagnostic trouble code to be set and will require wheel bearing and hub replacement. Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement .
1	Wheel Bearing Hub Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Procedure Apply the high-temperature, high-strength threadlocker to 2/3 of the threads of the wheel bearing hub and the bolt. TIP: Ensure that there are no gaps in the threadlocker and allow to dry approximately 10 minutes before installing the wheel bearing hub bolts. Tighten 130 N.m (96 lb ft)
2	Wheel Bearing and Hub

Callout

Component Name

CAUTION:

The wheel bearing and hub assembly includes a magnetic encoder with built-in permanent magnets that the wheel speed sensor senses. Any contact with another magnet will damage the encoder magnets. The damage will cause a diagnostic trouble code to be set and will require wheel bearing and hub replacement.

Preliminary Procedures

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement .

Wheel Bearing Hub Bolt (Qty: 3)

CAUTION:

Refer to Fastener Caution .

Procedure
Apply the high-temperature, high-strength threadlocker to 2/3 of the threads of the wheel bearing hub and the bolt.
TIP: Ensure that there are no gaps in the threadlocker and allow to dry approximately 10 minutes before installing the wheel bearing hub bolts.
Tighten
130 N.m (96 lb ft)

Wheel Bearing and Hub