LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 418 (Rear Suspension System) >> Repair Instructions >> Rear Spring, Insulator, and Jounce Bumper Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Spring & Insulator
    GM1860222Courtesy of GENERAL MOTORS COMPANY
  1. Position the spring seat (3), jounce bumper (2), rear spring (1), and the insulator (4) on the lower control arm.
  2. Using the adjustable jack stand, raise the lower control arm until the lower bolts for the knuckle can be installed. Refer to Knuckle Replacement .
  3. Remove the adjustable jack stand.
  4. Install the lower stabilizer shaft link bushing and nut. Refer to Stabilizer Shaft Link Replacement .
  5. Install the lower shock absorber bolt. Refer to Shock Absorber Replacement .
  6. Install the rear tire and wheels. Refer to Tire and Wheel Removal and Installation .
  7. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals