LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 417 (Front Suspension System) >> Repair Instructions >> Front Wheel Bearing and Hub Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the front brake rotor. Refer to Front Brake Rotor Replacement .
  4. Remove the wheel drive shaft retaining nut and washer. Refer to Front Wheel Drive Shaft Replacement .
  5. Install the J 42129  Wheel Hub Puller to the wheel bearing and hub.
  6. Using the J 42129  Wheel Hub Puller, separate the wheel drive shaft from the wheel bearing and hub.
  7. Remove the J 42129  Wheel Hub Puller from the wheel bearing and hub assembly.
    8. Fig 1: Wheel Hub And Bolts
    GM1866906Courtesy of GENERAL MOTORS COMPANY
  8. Remove the front wheel bearing hub bolts.
    9. Fig 2: Wheel Bearing And Hub Assembly
    GM1866925Courtesy of GENERAL MOTORS COMPANY
  9. Remove the wheel bearing and hub assembly.
scientia non olet · About LEMON Manuals