Instrument Cluster Replacement (Traverse)

Fig 1: View Of Instrument Cluster (Traverse)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the instrument panel cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Replacement (Traverse) .
1	Instrument Panel Cluster Trim Plate Spacer Screw (Qty: 6) CAUTION: Refer to Fastener Caution . Tighten: 2.5 N.m (22 lb in)
2	Instrument Panel Cluster Trim Plate Spacer
3	Instrument Panel Cluster Assembly Screw (Qty: 2) Tighten: 2.5 N.m (22 lb in)
4	Instrument Panel Cluster Assembly Procedure Disconnect the electrical connections. After replacing the instrument panel cluster, remove the instrument panel cluster fuse for a few seconds and then install the fuse. Refer to Control Module References for programming and setup information