Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0030, P0036, P0053, P0054, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0201-P0206, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0461, P0462, P0463, P0464, P0496, P0506, P0507, P1133, P1516, P2101, P2119, P2120, P2122, P2123, P2125, P2127, P2128, P2135, P2138, P2176, P2270, P2271, P2A00 are not set.
The engine is in Closed Loop status.
The Fuel Trim Learn is enabled.
The engine coolant temperature (ECT) is between -38 and +150°C (-36.4 and +302°F).
The intake air temperature (IAT) is between -38 and +150°C (-36.4 and +302°F).
The manifold absolute pressure (MAP) is between 10-105 kPa.
OR
The MAP is between 10-255 kPa for vehicles equipped with secondary air injection (AIR) reaction systems.
The vehicle speed is less than 300 km/h (186 mph).
The engine speed is between 400-7,000 RPM.
The mass airflow (MAF) is between 1-510 g/s.
The barometric pressure (BARO) is more than 70 kPa.
The fuel level is more than 10 percent.
DTC P0171 and P0172 run continuously when the above conditions have been met.