Conditions for Running the DTC: P1133
WARNING: This page is about a different variant/trim than selected.
- DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0451, P0452, P0454, P0455, P0496, P1516, P2101, P2119, P2135, P2176, P2A00 are not set.
- DTCs P0411, P0412, P0418, P2430, P2431, P2432, P2433, P2440, P2444 are not set, where applicable.
- The system voltage is between 10-18 volts.
- The scan tool special functions are not active.
- The HO2S Sensor 1 Heater command parameter is ON.
- The ECT Sensor parameter is more than 65°C (149°F).
- The Engine Run Time parameter is at least 60 seconds.
- The EVAP purge solenoid is commanded ON.
- The MAF sensor parameter is between 17-30 g/s.
- The Engine Speed parameter is between 1,300-2,550 RPM.
- The Fuel Alcohol Content parameter is less than 87 percent, 3.5L (RPO LZE), VIN Code K, E85 compatible engines only.
- The TP Indicated Angle parameter is greater than 3.5 percent.
- The Loop Status parameter is closed.
- The BARO parameter is at least 69.8 kPa.
- The vehicle is not in Park, Reverse, or Neutral.
- The above conditions have been met for one second.