Conditions for Running the DTC: P0133
WARNING: This page is about a different variant/trim than selected.
- DTCs P0030, P0053, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0134, P0135, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0451, P0452, P0454, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The system voltage is between 10-18 volts.
- The scan tool special functions are not active.
- The HO2S Sensor 1 Heater command parameter is ON.
- The ECT sensor parameter is more than 65°C (149°F).
- The Engine Run Time parameter is more than 60 seconds.
- The vehicle is not in Park, Reverse, or Neutral.
- The Loop Status parameter is closed.
- The MAF sensor parameter is between 17-30 g/s.
- The TP Indicated Angle parameter is more than 3.5 percent.
- The Engine Speed parameter is between 1,300-2,550 RPM.
- The evaporative emission (EVAP) system is purging.
- The Barometric (BARO) parameter is at least 69.8 kPa.
- The Fuel Alcohol Content parameter is less than 87 percent, 3.5L (RPO LZE), VIN code K, E85 compatible engines only.
- The above conditions have been met for one second.