LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 3.5L - Repair Instructions - Off Vehicle (2 Of 3)) >> Oil Pump Assemble >> Assemble

Oil Pump Assemble: Assemble

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate all the internal oil pump parts using engine oil during assembly.
    2. Fig 1: Identifying Oil Pump Gears
    GM1557729Courtesy of GENERAL MOTORS CORP.
  2. Install the oil pump gears.
    3. Fig 2: Identifying Oil Pump Cover
    GM1557727Courtesy of GENERAL MOTORS CORP.
  3. Install the oil pump cover.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the oil pump cover bolts and tighten to 10 N.m (89 lb in).
    5. Fig 3: Identifying Oil Pump Pressure Regulator Valve
    GM1557740Courtesy of GENERAL MOTORS CORP.
  5. Install the pressure regulator valve.
  6. Install the pressure regulator spring.
  7. Install the cotter pin.
    8. NOTE: Make sure the cotter pin is properly secured.
  8. Apply sealer GM P/N 12346004, (Canadian P/N 10953480) or the equivalent to the new suction pipe.
  9. Tap the new suction pipe into place using a plastic hammer and J-22144:  Oil Suction Pipe Installer.
scientia non olet · About LEMON Manuals