Engine Front Cover Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Front Cover & Gasket

Courtesy of GENERAL MOTORS CORP.

Install the front cover and the front cover gasket.

CAUTION: Refer to Fastener Caution .

NOTE: Apply sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the shaded bolts (1) in the graphic. Failure to do so may result in engine coolant leakage from the bolt holes passing through the water jacket.

Install the front cover bolts and tighten to 25 N.m (18 lb ft).