Crankshaft Balancer Removal: Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Crankshaft Balancer Bolt & Washer

Courtesy of GENERAL MOTORS CORP.

Remove the crankshaft balancer bolt and washer.

Fig 2: Identifying Crankshaft Balancer Removing Tool J 41816

Courtesy of GENERAL MOTORS CORP.

CAUTION: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool, and this can damage the component.

Remove the crankshaft balancer using the J-41816: Crankshaft Balancer Remover along with EN-46539: Puller End Protector.