LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Impala LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions - 2 Of 5)) >> On-Vehicle Repair Instructions (Part 2) >> Oil Pump Pipe and Screen Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil pan. Refer to Oil Pan Replacement .
    2. Fig 1: View Of Oil Pan Scraper And Bolts
    GM1210963Courtesy of GENERAL MOTORS CORP.
  2. Remove the oil pan scraper bolts.
  3. Remove the oil pan scraper.
    4. Fig 2: View Of Oil Suction Pipe
    GM1210965Courtesy of GENERAL MOTORS CORP.
  4. Remove the oil suction pipe bolts.
  5. Remove the oil suction pipe.
    6. Fig 3: View Of Oil Suction Tube Seal & Oil Suction Tube
    GM1318091Courtesy of GENERAL MOTORS CORP.
  6. Remove the oil suction tube seal from the oil suction tube. Discard the oil suction tube seal.
scientia non olet · About LEMON Manuals