LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Impala LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions - 2 Of 5)) >> On-Vehicle Repair Instructions (Part 2) >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
  2. Disconnect the oil pressure sensor electrical connector.
  3. Fig 1: View Of Oil Pressure Sender
    GM1210954Courtesy of GENERAL MOTORS CORP.
  4. Remove the oil pressure sensor.