LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Impala LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions - 2 Of 5)) >> On-Vehicle Repair Instructions (Part 2) >> Engine Oil Level Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Oil Level Switch
    GM1213854Courtesy of GENERAL MOTORS CORP.
  1. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement 
  2. Disconnect the electrical connector from engine oil level switch.
  3. Remove the engine oil level switch from the oil pan.
scientia non olet · About LEMON Manuals