LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Impala LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions - 2 Of 5)) >> On-Vehicle Repair Instructions (Part 2) >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Flywheel
    GM902811Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission. Refer to Transmission Replacement in Automatic Transmission - 4T65-E.
  2. Remove the engine flywheel bolts and the flywheel. Refer to Engine Flywheel Removal .
  3. Clean and inspect the flywheel. Refer to Engine Flywheel Cleaning and Inspection . If the flywheel teeth are damaged, inspect the starter for proper operation. Replace the starter if there is excessive wear or damage to the starter drive. Refer to Starter Motor Replacement (LY7) in Engine Electrical.
scientia non olet · About LEMON Manuals