LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> HHR L4-2.0L Turbo >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Service and Repair >> Overhaul >> Repair Instructions >> 68. Engine Oil Cooler Installation

68. Engine Oil Cooler Installation




Engine Oil Cooler Installation





Note: The oil cooler cannot be flushed or otherwise cleaned of contamination. Replace the oil cooler if a mechanical condition is suspected that could cause the oil cooler to be contaminated.

1. Install the oil cooler.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the oil cooler bolts and tighten to 25 Nm (18 lb ft).

scientia non olet · About LEMON Manuals