Camshaft Bearing: Specifications

CAMSHAFT BEARING CAP TORQUE AND SEQUENCE

Install the exhaust camshaft caps and hand start the camshaft cap bolts.
Tighten the camshaft cap bolts in increments of 3 turns until they are seated.
Tighten the camshaft caps to 10 Nm (89 lb in)






Install the number 6 intake camshaft rear cap.
Tighten the cap bolts evenly to 5 Nm (44 lb in).
Tighten the cap bolts evenly to 10 Nm (89 lb in)
Back the cap bolts out 120 degrees.
Tighten the cap bolts evenly a final pass to 10 Nm (89 lb in)