LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Manual Transmission - Mu3) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the underhood electrical center bracket from the vehicle and reposition the electrical center. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
    2. Fig 1: Supporting Engine/Transmission With Hydraulic Floor Jack
    GM851552Courtesy of GENERAL MOTORS CORP.
  2. Support the transmission with a floor jack. Use a piece of wood between the jack and the transmission.
    3. Fig 2: View Of Transmission Mount To Transmission Bolts
    GM1376169Courtesy of GENERAL MOTORS CORP.
  3. Remove the transmission mount-to-transmission bracket bolts.
    4. Fig 3: View Of Transmission Mount-To-Mid-rail Bolts
    GM851557Courtesy of GENERAL MOTORS CORP.
  4. Remove the transmission mount to mid-rail bolts.
    5. Fig 4: Supporting Engine/Transmission With Hydraulic Floor Jack
    GM851552Courtesy of GENERAL MOTORS CORP.
  5. Using a floor jack, slowly lower the transmission enough to remove the transmission mount from the vehicle.
scientia non olet · About LEMON Manuals