LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Manual Transmission - Mu3) >> Repair Instructions - On Vehicle >> Axle Seals Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation .
  3. Remove the wheel driveshaft or intermediate drive shaft. Refer to Wheel Drive Shaft Replacement or Front Wheel Drive Intermediate Shaft Replacement .
    4. Fig 1: Removing Front Wheel Drive Shaft Oil Seal
    GM863208Courtesy of GENERAL MOTORS CORP.
  4. Use the J 23907  or J 44809  in order to remove the seal. See Special Tools .
  5. Inspect the seal bore for nicks or for burrs. Clean the bore with a fine grade sandpaper, if necessary.
scientia non olet · About LEMON Manuals