LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Manual Transmission - Mu3) >> Repair Instructions - On Vehicle >> Axle Seals Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Axle Seal
    GM895455Courtesy of GENERAL MOTORS CORP.
  1. Use the J 23907  or J 44809  to install a new seal. See Special Tools . Ensure the seal is seated flush to the outer bore area.
  2. Install the wheel driveshaft or intermediate drive shaft. Refer to Wheel Drive Shaft Replacement or Front Wheel Drive Intermediate Shaft Replacement .
  3. Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals