Intake Air Pressure and Temperature Sensor Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Intake Air Pressure and Temperature Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the charge air cooler outlet pipe. Refer to Charge Air Cooler Outlet Pipe Replacement .
1	Sensor Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 9 N.m (80 lb in)
2	Intake Air Pressure and Temperature Sensor Procedure: Disconnect the electrical connector.