LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Vent Solenoid Valve Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  2. Disconnect the evaporative emission (EVAP) canister harness electrical connector (1) from the fuel tank pressure sensor.
    3. Fig 2: Identifying Fuel Tank Pressure Sensor
    GM1742792Courtesy of GENERAL MOTORS CORP.
  3. Using a small flat-bladed screwdriver, carefully lift and release the fuel tank pressure sensor from the EVAP canister.
scientia non olet · About LEMON Manuals