LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Chassis to Canister >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Line & Retainers
    GM2034701Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP line into the plastic retainers (3).
  2. Connect the EVAP line to the plastic retainers (2).
  3. Connect the quick connect fitting (1). Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 2: View Of Evaporative Emission Hoses/Pipes - Chassis/Canister
    GM2034674Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP line to the plastic retainers (2).
    5. CAUTION: Refer to Fastener Caution .
  5. Install the retaining nuts (1) and tighten to 10 N.m (89 lb in).
  6. Remove the caps or plugs from the purge pipe and the engine purge hose.
  7. Connect the purge pipe to the engine purge hose. Refer to Evaporative Emission Line Replacement - Engine to Chassis .
scientia non olet · About LEMON Manuals