LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Vent Solenoid Valve Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the evaporative emission (EVAP) canister harness electrical connector (2) from the EVAP vent solenoid valve.
  3. Clean away any debris that may be present around the EVAP canister vent solenoid valve.
    4. Fig 2: View Of EVAP Canister Bolt
    GM1652165Courtesy of GENERAL MOTORS CORP.
  4. Remove the EVAP canister bolt.
  5. Lower the EVAP canister.
    6. Fig 3: Identifying EVAP Canister Vent Valve
    GM1742796Courtesy of GENERAL MOTORS CORP.
  6. Rotate the EVAP canister vent solenoid valve counterclockwise in order to release it from the locked position.
    7. Fig 4: Identifying EVAP Canister
    GM1742802Courtesy of GENERAL MOTORS CORP.
  7. Remove the EVAP canister vent solenoid valve from the canister.
scientia non olet · About LEMON Manuals