LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Charge Air Cooler Outlet Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Charge Air Cooler Outlet Pipe
    GM2002696Courtesy of GENERAL MOTORS CORP.
  1. Loosen the charge air cooler outlet pipe clamp (1) at the intake manifold (2).
  2. Disconnect the engine wiring harness electrical connector from the intake air pressure and temperature sensor.
  3. Reposition the hose clamp and remove the vacuum hose from the outlet pipe.
  4. Remove the right engine splash shield. Refer to Engine Splash Shield Replacement - Right Side .
    5. Fig 2: View Of Charge Air Cooler Outlet Pipe Clamp & Charge Air Cooler Assembly
    GM2002697Courtesy of GENERAL MOTORS CORP.
  5. Loosen the charge air cooler outlet pipe clamp (1) at the charge air cooler assembly (2).
  6. Remove the charge air cooler outlet pipe (3).
scientia non olet · About LEMON Manuals