LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Turbocharger Oil Feed Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Turbocharger Oil Feed Pipe Bolts And Pipe
    GM2003826Courtesy of GENERAL MOTORS CORP.
  1. Install NEW gaskets onto the turbocharger oil feed pipe fittings.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the turbocharger oil feed pipe and bolts (1).

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  3. Install the thermostat housing. Refer to Engine Coolant Thermostat Housing Replacement (LNF) .
scientia non olet · About LEMON Manuals