LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Starter And Engine Electrical Connectors
    GM1809558Courtesy of GENERAL MOTORS CORP.
  1. Remove the starter. Refer to Starter Replacement .
  2. Disconnect the engine wiring harness electrical connector (2) from the oil pressure switch.
    3. Fig 2: View Of Engine Oil Pressure Sensor
    GM630350Courtesy of GENERAL MOTORS CORP.
  3. Remove the engine oil pressure switch.
scientia non olet · About LEMON Manuals