LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Engine Flywheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Flywheel & Retaining Bolts
    GM412117Courtesy of GENERAL MOTORS CORP.
  1. Position the flywheel on the crankshaft as previously noted.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the flywheel bolts and tighten to 53 N.m (39 lb ft) plus 25 degrees.
  3. Install the transmission. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals