LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission. Refer to Transmission Replacement .
    2. Fig 1: Identifying Flywheel & Retaining Bolts
    GM412117Courtesy of GENERAL MOTORS CORP.
  2. Remove the flywheel.
    3. Fig 2: View Of Crankshaft Rear Oil Seal
    GM406046Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not damage the outside diameter of the crankshaft or chamber with any tool.
  3. Pry the crankshaft rear oil seal with a flat-bladed tool.
scientia non olet · About LEMON Manuals