LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Driveline/Axle) >> Driveshaft Inspection

Driveshaft Inspection

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and the boot bands.
    Fig 1: Identifying Inboard Boot, Outboard Boot, Driveshaft And Loose Boot Bands
    G06430368Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Check the driveshaft for cracks and damage. If any damage is found, replace the driveshaft.
  3. Check the inboard joint (E) and the outboard joint (F) for cracks and damage. If any damage is found, replace the inboard joint or the outboard joint as an assembly.
  4. Hold the inboard joint and turn the front wheel by hand, then make sure the joint is not excessively loose. If necessary, replace the inboard joint or the outboard joint as an assembly.
scientia non olet · About LEMON Manuals