LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Front Suspension And Rear Suspension (Inspection)) >> Wheel Bolt Replacement >> Front

Wheel Bolt Replacement: Front

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle on a lift (see LIFT AND SUPPORT POINTS ).
  2. Remove the front hub (see KNUCKLE/HUB REPLACEMENT ).
  3. Separate the wheel bolt (A) from the hub (B) using a hydraulic press. Support the hub with hydraulic press attachments (C) or equivalent tools.
    NOTE: Before installing the new wheel bolt, clean the mating surfaces on the bolt and the hub.
    Fig 1: Identifying Wheel Bolt And Hub
    G06430567Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Insert the new wheel bolt into the hub while aligning the splined surfaces on the hub hole with the wheel bolt.
    NOTE:
    • Degrease all around the wheel bolt.
    • Make sure the wheel bolt is installed vertically in relation to the hub disc surface.
  5. Install the wheel bolt using a hydraulic press until the wheel bolt shoulder is fully seated.
  6. Install the front hub (see KNUCKLE/HUB REPLACEMENT ).
    NOTE: If you cannot tighten the wheel nut to the specified torque value when installing the wheel, replace the front hub as an assembly.
scientia non olet · About LEMON Manuals