Camber Inspection
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
Use commercially available computerized four wheel alignment equipment to measure wheel alignment (caster, camber, toe, and turning angle). Follow the equipment manufacturer's instructions.
- Check the camber angle.
Camber angle:
Front: 0°00'±1°
(Maximum difference between the right and left side: 0°45')
Rear: -1°00'±1°
- If the measurement for the front camber is outside the specification, go to FRONT CAMBER ADJUSTMENT .
- If the measurement for the rear camber is outside the specification, check for bent or damaged suspension components.