The Bluetooth icon in the navigation display is not displayed
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch to LOCK (0).
- Remove the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ), and disconnect audio-navigation unit connector B (24P).
- Disconnect the HandsFreeLink control unit 28P connector.
- Check for continuity between HandsFreeLink control unit 28P connector terminal No. 19 and body ground.Fig 1: Checking Continuity Between HandsFreeLink Control Unit 28P Connector Terminal No. 19 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Repair a short to body ground in the wire between HandsFreeLink control unit and audio-navigation unit.
NO -Go to Step 5.
- Check for continuity between HandsFreeLink control unit 28P connector terminal No. 19 and audio-navigation unit connector B (24P) terminal No. 20.Fig 2: Checking Continuity Between HandsFreeLink Control Unit 28P Connector And Audio-Navigation Unit Connector B (24P)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Substitute a known-good HandsFreeLink control unit (see CONTROL UNIT INPUT TEST/REPLACEMENT ), and recheck. If the symptom goes away, replace the original HandsFreeLink control unit. If the symptom does not go away, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).
NO -Repair an open in the wire between the HandsFreeLink control unit and the audio-navigation unit.