LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Turn Signal/Hazard Warning Lights) >> Hazard Warning Switch Test/Replacement

Hazard Warning Switch Test/Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the center panel.
  2. Remove the two screws and the hazard Warning switch (A).
    Fig 1: Identifying Screws And Hazard Warning Switch
    G06431604Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals in each switch position according to the table.
    Fig 2: Continuity Chart
    G06431605Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. If the continuity is not as specified for terminals 1 and 2, replace the switch (A). If the continuity is not as specified for terminals 4 and 5, replace the bulb (B).
    Fig 3: Identifying Switch And Bulb
    G06431606Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the switch in the reverse order of removal.
scientia non olet · About LEMON Manuals