LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Keyless/Power Door Locks/Security System) >> Symptom Troubleshooting >> Driver's door lock knob switch circuit troubleshooting

Driver's door lock knob switch circuit troubleshooting

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to ON (II).
  2. With the driver's door lock knob switch in LOCK position, select SECURITY with the HDS, and enter the DATA LIST.
  3. Check the ON/OFF information of the DRIVER'S DOOR LOCK KNOB SWITCH (UNLOCK) in the DATA LIST.

    Is the data list value indicated ON? 

    YES  -Go to step 4.

    NO  -Go to step  8.

  4. Disconnect the driver's door lock actuator/knob switch 10P connector.
  5. Check the ON/OFF information of the DRIVER'S DOOR LOCK KNOB SWITCH (UNLOCK) in the DATA LIST.

    Is the data list value indicated OFF? 

    YES  -Faulty driver's door lock knob switch; replace the door latch (see FRONT DOOR LATCH REPLACEMENT ).

    NO  -Go to step 6.

  6. Disconnect under-dash fuse/relay box connector E (12P).
  7. Check the ON/OFF information of the DRIVER'S DOOR LOCK KNOB SWITCH (UNLOCK) in the DATA LIST.

    Is the data list value indicated OFF? 

    YES  -Repair a short to ground in the wire.

    NO  -Faulty MICU; replace the under-dash fuse/relay box.

  8. Disconnect the driver's door lock actuator/knob switch 10P connector.
  9. Connect driver's door lock actuator/knob switch 10P connector terminal No. 7 and body ground with a jumper wire.
    Fig 1: Connecting Driver's Door Lock Actuator/Knob Switch 10P Connector Terminal No. 7 And Body Ground
    G00500499Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Check the ON/OFF information of the DRIVER'S DOOR LOCK KNOB SWITCH (UNLOCK) in the DATA LIST.

    Is the data list value indicated ON? 

    YES  -Go to step 11.

    NO  -Go to step  12.

  11. Check for continuity between driver's door lock actuator/knob switch 10P connector terminal No. 5 and body ground.
    Fig 2: Checking Continuity Between Driver's Door Lock Actuator/Knob Switch 10P Connector Terminal No. 5 And Body Ground
    G00500500Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Faulty driver's door lock knob switch; replace the door latch (see FRONT DOOR LATCH REPLACEMENT ).

    NO  -Repair an open or high resistance in the wire or poor ground (G501).

  12. Connect under-dash fuse/relay box connector E (12P) terminal No. 2 and body ground with a jumper wire.
    Fig 3: Connecting Under-Dash Fuse/Relay Box Connector E (12P) Terminal No. 2 And Body Ground
    G00500501Courtesy of AMERICAN HONDA MOTOR CO., INC.
  13. Check the ON/OFF information of the DRIVER'S DOOR LOCK KNOB SWITCH (UNLOCK) in the DATA LIST.

    Is the data list value indicated ON? 

    YES  -Repair an open or high resistance in the wire.

    NO  -Faulty MICU; replace the under-dash fuse/relay box.

scientia non olet · About LEMON Manuals