LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Keyless/Power Door Locks/Security System) >> Door Lock Knob Switch Test >> Rear Door

Rear Door

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left or right rear door panel (see REAR DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 10P connector (A) from the actuator (B).
    NOTE: The illustration shows the left rear door.
    Fig 1: Identifying 10P Connector And Actuator
    G06431531Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals.

    There should be continuity between terminals No. 7 [No. 8] and No. 5 [No. 10] when the door lock knob switch is in the UNLOCK position and no continuity when the switch is in the LOCK position.

    []: Right rear door

  4. If the continuity is not as specified, replace the rear door latch assembly (see REAR DOOR LATCH REPLACEMENT ).
scientia non olet · About LEMON Manuals