Right Rear Door
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the right rear door panel (see REAR DOOR PANEL REMOVAL/INSTALLATION ).
- Disconnect the 10P connector (A) from the actuator (B).
- Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
- If the actuator does not operate as specified, replace the rear door latch assembly (see REAR DOOR LATCH REPLACEMENT ).