Front Bumper Side Cover Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Put on gloves to protect your hands.
Take care not to scratch the front bumper.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

Insert a flat-tip screwdriver, wrapped with protective tape into the slot (A), then pull out the hook (B). Slide the front bumper side cover toward the middle of the vehicle to detach the hook (C), and remove the cover (D).

Fig 1: Identifying Front Bumper Side Cover Hook
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the front bumper side cover in the reverse order of removal, and push the hook into place securely.