System locks up or freezes constantly
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Check the vehicle battery condition first (see 12 VOLT BATTERY TEST ).
- Check for connectors for poor connections or loose terminals.
- Always check for and resolve all CAN DTCs before troubleshooting the navigation system.
- Verify that the correct audio-navigation unit is installed for this model. Go into the System Diagnostic Mode, and use Version (see VERSION ).
- Make sure that the correct DVD color and version are installed.
- Inspect the navigation DVD for dirt or damage.
- Check any official Honda service website for more information about the navigation system.
- Turn the ignition switch to ON (II).
- Remove the navigation DVD, and check the navigation DVD reading surface for scratches and finger prints.
Are there any scratches or finger prints on the navigation DVD reading surface?
YES -Clean or replace the navigation DVD, and recheck (see DVD HANDLING AND CLEANING ).
NO -Go to step 3.
- Turn the ignition switch to LOCK (0), and then back to ON (II).
Does the system reboot?
YES -Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).
NO -The system is OK at this time. Go into the System Diagnostic Mode, select Detail Information & Settings, and use the Unit Check test to check the unit status (see UNIT CHECK (QUICK CHECK) ). If the status is NG, replace the audio-navigation unit.